Lenovo Converged HX Series Installation And Service Manual page 183

1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Check the status of the fans. If any of the fans is broken, replace it with a new one.
3. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
01010920
Full Sensor Name (Sensor Name In SDR):
Inlet_Temp
Sensor Type:
Temperature
Event Severity:
Critical
Description:
Upper Critical - Going High - Asserted
Message:
Inlet temperature is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Check the status of the fans. If any of the fans is broken, replace it with a new one.
3. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
01010720
Full Sensor Name (Sensor Name In SDR):
Inlet_Temp
Sensor Type:
Temperature
Event Severity:
Warning
Description:
Upper Non-Critical - Going High - Asserted
Message:
Inlet temperature is too high
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Check the status of the fans. If any of the fans is broken, replace it with a new one.
3. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
01010B21
Full Sensor Name (Sensor Name In SDR):
Appendix A. TMM error messages
169