Tmm Error Messages - Lenovo Converged HX Series Installation And Service Manual

SNMP Trap ID
The SNMP trap ID that is found in the SNMP alert management information base (MIB).
Automatically contact Service
If this field is set to Yes, and you have enabled Electronic Service Agent (ESA), Lenovo Support will be
notified automatically if the event is generated.
While you wait for Lenovo service representative to call, you can perform the recommended actions for
the event.
User response
Indicates what actions you should perform to solve the event.
Perform the steps listed in this section in the order shown until the problem is solved. After you perform
all of the actions that are described in this field, if you cannot solve the problem, contact Lenovo service
representative.
Note: This list includes error codes and messages that might not apply to this machine type and model.
The following is the list of TMM error messages and suggested actions to correct the detected server
problems. For more information about TMM, see the TMM User's Guide.

TMM error messages

Use this information to resolve any issues that were found.
• Diagnostic Code:
04010401
04010402
04010403
04010404
04010405
Full Sensor Name (Sensor Name In SDR):
Fan%_Speed (% = Fan number)
Sensor Type:
Fan
Event Severity:
Critical
Description:
Lower Non-Recoverable - Going Low - Asserted
Message:
Fan% speed is too low.
Actions:
1. Check Lenovo Data Center Support site for an applicable retain tip or firmware update that applies to
this error.
2. Check the status of the fans. If any of the fans is broken, replace it with a new one.
3. If the error recurs, contact Lenovo service representative for technical support.
• Diagnostic Code:
158
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide