Lenovo Converged HX Series Installation And Service Manual page 152

• When using the installation tool, twist the handle of the installation tool assembly
counterclockwise until the microprocessor is inserted into the socket, and lift the installation
tool out of the socket.
Figure 76. Installation tool handle adjustment
Figure 77. Installation Tool
Attention:
• Do not press the microprocessor into the socket.
• Make sure that the microprocessor is oriented and aligned correctly in the socket before
you try to close the microprocessor retainer.
• Do not touch the thermal material on the bottom of the heat sink or on top of the
microprocessor. Touching the thermal material will contaminate it.
Step 7. Remove the microprocessor cover, tape, or label from the surface of the microprocessor socket, if
one is present. Store the cover in a safe place.
Figure 78. Socket cover removal
138
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
Lock Position
E5-x6xx v3
E5-x6xx v4
Unlock Position