Removing A Satadom - Lenovo Converged HX Series Installation And Service Manual

PCI riser assembly
Figure 58. PCI riser-card assembly installation
Step 4. Tighten the PCI riser-card assembly with 3 M3 screws.
Step 5. Reinstall compute node (see "Installing a compute node in a chassis" on page 82).
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect any cables that you removed.
3. Turn on the peripheral devices and the server.

Removing a SATADOM

Use this information to remove a SATADOM.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
If you are replacing a server component or installing an optional device in the server, you need to take out the
node out from the rack enclosure, turn off the server and peripheral devices, and disconnect all external
cables.
To remove a SATADOM, complete the following steps.
Step 1. Disconnect the external cables from the compute node.
Step 2. Remove the compute node (see "Removing a compute node from a chassis" on page 81).
Step 3. Press the latch of the SATADOM.
Step 4. Carefully grasp the SATADOM by its top edge or upper corners, and pull the SATADOM out of the
connector.
124
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide