Removing The Node Sata Cable - Lenovo Converged HX Series Installation And Service Manual

Front I/O (left)
Fan board
SMB board
Front I/O (right)
Thermal sensor
Figure 96. Internal cable routing and connectors on the front I/O and the fan board
The following illustration displays the location of the thermal sensor.
Thermal sensor
Figure 97. The location of the thermal sensor

Removing the node SATA cable

Use this information to remove the node SATA cable from the server.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
If you are replacing a server component or installing an optional device in the server, you need to take out the
node out from the rack enclosure, turn off the server and peripheral devices, and disconnect all external
cables.
152
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide