The following figure illustrates the pin assignment of BG955A-GL.
NOTE
1.
ADC input voltage must not exceed 1.8 V.
2.
Keep all RESERVED pins and unused pins unconnected.
3.
GND pins should be connected to ground in the design.
4.
Only BG951A-GL supports GNSS_BOOT (pin 75), GNSS_NRST (pin 76), GNSS_EN (pin 97) and
BG95xA-GL_Hardware_Design
Figure 7: Pin Assignment of BG955A-GL (Top View)
LPWA Module Series
24 / 102