Advertisement
Quick Start Guide
3
Mounting the transmitter with a strap
3.1
Mounting the transmitter
If you are using the strap mounting option, perform the tasks in this
section.
If you are using the magnetic fixture, skip this section and go to the
Mounting the transmitter with a magnetic
WARNING
Two people are required for this operation
Personal protective equipment (PPE) of gloves and safety glasses
or full-face visor are recommended.
Cut strap may have sharp edges.
Do not cut the strap while it is under tension because this action
can result in damage or injury.
Procedure
1. Unbox the strap tensioner and the strap from the packaging.
2. Feed the strap into one end of the strap tensioner and using
the screwdriver or wrench and socket provided, turn the screw
on the tensioner until the end of the strap emerges from
under the worm drive (at least 5 turns of the worm-screw are
required).
3. Remove the protective cap from the sensor.
Once the protective cap is removed, the strong magnetic field
at the end of the sensor can suddenly attract other objects,
such as tools. This can cause injury as well as damage to the
sensor.
Only remove the protective cap when necessary and then take
great care. Ensure tools and fastenings are kept away from the
sensor when the cap is removed.
4. Carefully place the sensor on the required location on the
pipe.
5. Check the sensor is on the location correctly and the
thermocouple is in contact with the surface.
10
CAUTION
fixture.
Emerson.com/Rosemount
April 2023
Advertisement
