Configuration Requirements
The following table shows the configuration requirements of AUX login.
Device
Terminal
The port properties of the hyper terminal must be the same as the default settings of the AUX port
shown in the following table.
Bits per second
Flow control
Parity
Stop bits
Data bits
Login Procedure
Step1 As shown in
Figure
device. Plug the DB-9 connector of the console cable into the serial port of the PC, and plug the RJ-45
connector into the AUX port of your device.
Figure 3-20 Connect the device and PC
Identify the interface to avoid connection errors.
Object
Setting
3-20, use the console cable shipped with the device to connect the PC and the
Configure the authentication mode. For more information, see
Configuring None Authentication for AUX
Password Authentication for AUX
Authentication for AUX
Login.
Run the hyper terminal program.
Configure the hyper terminal attributes.
9,600 bps
On for an independent AUX port
None
1
8
3-59
Requirements
Login,
Configuring
Login, and
Configuring Scheme
Default