Modifying The Level Of A Command - H3C SR6600 Fundamentals Configuration Manual

User interface
authentication
mode
When the authentication mode is set to local, configure the local password before switching to a
higher user privilege level.
When the authentication mode is set to scheme, configure AAA related parameters before
switching to a higher user privilege level.
The privilege level switch fails after three consecutive unsuccessful password attempts.
For more information about user interface authentication, see Logging In to the Device in the
Fundamentals Configuration Guide.

Modifying the Level of a Command

All the commands in a view are defaulted to different levels. The administrator can change the default
level of a command to a lower level or a higher level as needed.
Follow these steps to modify the command level:
To do...
Enter system view
Configure the command level in a
specified view
User privilege level
switch
authentication
mode
local scheme
scheme
scheme local
Use the command...
system-view
command-privilege level level
view view command
Information input for the
first authentication mode
Local user privilege level
switch password
Password for privilege level
switch (configured on the
AAA server). The system
uses the username used for
logging in as the privilege
level switch username.
Password for privilege level
switch (configured on the
AAA server). The system
uses the username used for
logging in as the privilege
level switch username.
1-21
Information input after the
authentication mode changes
Password for privilege level
switch (configured on the AAA
server). The system uses the
username used for logging in as
the privilege level switch
username.
—
Local user privilege level switch
password
Remarks
—
Required
Table 1-5 for the default
See
settings.