Displaying And Maintaining The Tftp Client - H3C SR6600 Fundamentals Configuration Manual

If the source address is specified with the tftp client source or tftp command, this source address
is adopted.
If you use the tftp client source command and the tftp command to specify a source address
respectively, the source address configured with the tftp command is used to communicate with a
TFTP server.
The source address specified with the tftp client source command is valid for all TFTP connections
and the source address specified with the tftp command is valid only for the current tftp connection.
Follow these steps to configure the TFTP client:
To do...
Enter system view
Use an ACL to control the device's
access to TFTP servers
Configure the source address of
the TFTP client
Return to user view
Download or upload a file in an
IPv4 network
Download or upload a file in an
IPv6 network
If no primary IP address is configured on the source interface, no TFTP connection can be
established.
If you use the ftp client source command to first configure the source interface and then the
source IP address of the packets of the TFTP client, the new source IP address will overwrite the
current one, and vice versa.

Displaying and Maintaining the TFTP Client

To do...
Display the configuration of the
TFTP client
Use the command...
system-view
tftp-server [ ipv6 ] acl acl-number
tftp client source { interface
interface-type interface-number | ip
source-ip-address }
quit
tftp server-address { get | put | sget }
source-filename
[ destination-filename ]
[ vpn-instance vpn-instance-name ]
[ source { interface interface-type
interface-number | ip
source-ip-address } ]
tftp ipv6 tftp-ipv6-server [ -i
interface-type interface-number ]
{ get | put } source-file
[ destination-file ]
Use the command...
display tftp client configuration
7-104
Remarks
—
Optional
By default, no ACL is used to
control the device's access to
TFTP servers.
Optional
A device uses the source
address determined by the
matched route to communicate
with the TFTP server by default.
—
Optional
Available in user view
Optional
Available in user view
Remarks
Available in any view