Table of Contents
Advertisement
`~êÇ=fåëÉêíáçå
To insert a card:
1.
2.
3.
4.
Card
Figure 3-8. Ejector Orientation prior to card insertion
FSN-1004 • User's Guide • Rev 00
Use
Table 3-2
on page 59 to verify the slots in which the card can be installed.
Once verified, open the chassis front door and remove it (if desired). In
Chapter 2, refer to the
"Chassis Front
Orient the card so that the label (e.g., UIC) is at the top. Ensure that both ejectors
are unlatched from the slots in the card's front plate.
Once unlatched, hold the top ejector up, as shown below. The bottom ejector will
automatically fall away from the front of the card.
Door" section on page 28 for details.
Hold up
top Ejector
Bottom Ejector
3. Installation
Card and Rear Panel
61
Advertisement
Table of Contents
