Barco FSN-1004 User Manual page 148

4. Menu Orientation
System Menu
Aspect
Ratio
16:9
•
Pan
Zoom
Source
148
• Aspect ratio is maintained. Manual size/position adjustments
using the four value buttons are maintained.
• If the top and/or bottom edges of the image are manually
masked, those edges are used for the Fill V calculations.
• Black pillars are visible to the left and right of an image, for
example, when a 4:3 image is scaled up to 16:9.
• The left and right portions of an image may fall outside of the
raster, for example, when a 16:9 image is scaled down to 4:3.
~
Press {Fill H/V} to scale the output up (or down) to the selected
horizontal and vertical resolutions. Please note:
• Aspect ratio is not maintained. Non-proportional image
stretching or compression will occur.
• If any edges of the image are manually masked, those edges
are used for the Fill H/V calculations.
~
Use the {Reset} function to reset all size and position values to default.
When {Size and Position} is selected, one additional function is available in the
Tool Bar :
~
Press {Aspect Ratio} to display the Aspect Ratio Pop-up . This
function affects the output's H dimension only. Choices are 16:9, 5:4,
4:3, 3:2, 1:1 and Custom.
When {Custom} is selected, the {Adjust Custom Aspect} button
appears in the Tool Bar . Press to display the {Custom Aspect} value
button. Unlatch to re-display size and position adjustments.
In the Output Sizing and Scaling section, press {Pan Zoom Source} to display
four buttons which enable you to size and position the video within the boundaries
of the output's current sizing. In this mode, the output's outside boundaries
remain constant, but you can pan and zoom the video inside, as desired.
Note The Pan Zoom Source function does not allow you to reveal
video that is outside of the output's active area.
The following functions are provided:
~
Press {Source H Size} to change horizontal size inside the output's
boundaries. Remember that {Source H Size} and {Source V Size}
track together if the {Lock} is enabled.
~
Press {Source V Size} to change vertical size inside the output's
boundaries.
~
Press the {Lock} button to lock or unlock H and V source size tracking.
When locked, both parameters track together. When unlocked, H and V
can be adjusted independently.
~
Press {Source H Pos} to change the horizontal position inside the
output's boundaries along the X axis.
~
Press {Source V Pos} to change the vertical position inside the output's
boundaries along the Y axis.
FSN-1004 • User's Guide • Rev 00