Barco FSN-1004 User Manual page 146

4. Menu Orientation
System Menu
•
Active
and
Pos
•
Sync
•
Offset
Timing
•
Offset
Timing
Info
lìíéìí=páòáåÖ=~åÇ=pÅ~äáåÖ=m~åÉä
From the SOC Setup Menu , press {Sizing and Scaling} to display the Output Sizing and
Sizing
Scaling Panel . This panel enables you to size and scale the universal output to a different
and
size, position, resolution and mask, as required.
Scaling
The panel has one Output Sizing and Scaling section, (as shown below) plus additional
146
~
Press {V Total} to set the desired total number of vertical lines in the
output image.
Important Changing the H and V Totals will cause a disruption to the
SOC's output video. Press {Apply} to apply changes, or
{Undo} to reverse un-applied changes.
Press {Active and Pos} to set the H and V active area, and the H and V position.
Four value buttons appear:
~
Press {H Pos} to set the start of the active area's horizontal offset from H
sync, in pixels.
~
Press {V Pos} to set the start of the active area's vertical offset from V
sync, in lines.
~
Press {H Active} to set the width of the active area, in pixels.
~
Press {V Active} to set the number of active vertical lines in the output.
Press {Sync} to adjust the horizontal and vertical sync pulse width. Two value
buttons appear:
~
Press {H Sync} to adjust the horizontal sync pulse width, in pixels.
~
Press {V Sync} to adjust the vertical sync pulse width, in lines.
Press {Offset Timing} to adjust the SOC output's video timing relative to the
system's native resolution. Please note:
~
If the selected SOC output format is vertically locked to the native
resolution's vertical sync, the {Offset Timing} button is active.
~
If the selected SOC format is not vertically locked to the native
resolution's vertical sync, the {Offset Timing} button is grayed out.
When {Offset Timing} is pressed, two value buttons appear, along with the
{Offset Timing Info} button:
~
Press {H Offset} to offset the output's horizontal timing (in pixels),
relative to the timing of the system's native resolution. The adjustment
range is +/- 1/2 line.
~
Press {V Offset} to offset the output's vertical horizontal timing (in lines),
relative to the timing of the system's native resolution. The adjustment
range is +/- 1/2 frame.
Press {Offset Timing Info} to display a pop-up with the following important
information on video output offset timing:
~
If the reference input is set to External , H and V offsets adjust the video
output relative to the video reference input. H and V can be positive or
negative values.
~
If the reference input is set to Free Run , H and V offsets adjust the video
output relative to the switcher's internal Black signal.
FSN-1004 • User's Guide • Rev 00