Barco FSN-1004 User Manual page 172

5. System Setup
Universal Input Setup
råáîÉêë~ä=fåéìí=pÉíìé
FSN-1004 system setup: Step 7
In this procedure, you will perform a complete setup on all universal switcher inputs.
7
Ensure that your inputs are properly connected to the selected UIC before continuing.

Universal Input Setup
1.
2.
3.
4.
5.
6.

Capture and Timing
timing parameters:
1.
2.
3.
172

Prerequisite — Ensure that you are familiar with the following menus:
~
Input Menu — Chapter 4, "
~
Connector Colors — Chapter 4, "
~
Input Setup Menu (Universal Inputs) — Chapter 4, "
Menu ," page 123.
— Use the following steps for basic universal input setup:
In the Menu Bar , press {System} to access the System Menu .
Press {Input Setup} to display the Input Menu .
Note Remember that after a factory reset, UIC inputs are not
mapped to the GUI, but default names are assigned.
In the Rear I/O View , press the input connector on the UIC that you want to set
up. A yellow highlight is placed around all three input connectors, and in the Input
Table , the input is highlighted.
Select the individual UIC connector — either the BNC , HD-15 or DVI . A green
highlight indicates the selection.
Press {Input Name} to name (or re-name) the selected input. When the pop-up
Keyboard appears, enter the desired name and press {Enter} on the Keyboard .
Press {Error Reporting} to turn error reporting on or off.
~
When on , if an input experiences an error, the connector turns red on the
rear I/O view, the input's Programmable Display turns red, and the
" Error " button appears.
~
When off , the input's Programmable Display remains green and the
red " Error " button does not appear. The connector remains red.
Note The {Error Reporting} function works on a connector-by-
connector basis.
— Use the following steps to set up universal input capture and
Press {Setup} to display the Input Setup Menu for the selected universal input.
Press {Capture and Process} to display the Capture and Process Panel .
Press {Auto Acquire} to toggle the Auto Acquire mode On or Off as required.
~
When Off , you can set the resolution using the {Input Format} button.
~
When On , the system attempts to detect the resolution. When a match
is found, the format is applied and the Format field in the table is
Input Setup ," page 117.
Connector Colors
Input Setup
FSN-1004 • User's Guide • Rev 00
," page 119.