Table of Contents
Advertisement
4. Menu Orientation
System Menu
oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå
The figure below illustrates a sample Rear I/O View on the Input Menu :
Figure 4-48. Input Menu, Rear I/O View (sample)
The Rear I/O View shows the I/O panels for FSN-1004 slots 3 through 7 . This view always
matches your system configuration exactly — based on the installed cards. Please note:
•
•
•
•
Analog 1
DVI 1
SDI 1
Refer to the "
I/O View connectors.
118
The number of each slot is shown along the top.
The type of each installed card is shown along the bottom (e.g., UIC ).
If a card is not installed, the label " Not Installed " appears in the slot.
To set up an input on a UIC card:
~
Press any of the top three connectors to select Input 1 , or any of the
bottom three connectors to select Input 2 . The selected input is
highlighted with a yellow border around all three connectors.
~
Next, press the desired connector (either Analog , DVI or SDI ) to
highlight it with a green border. This indicates that the connector is
selected, and in the Input Table , the input is automatically highlighted.
Please note:
~
When you switch connectors on the UIC , freeze will always be turned off.
If " Black on Invalid Video " is turned on, the input will go black as it
acquires the new input.
Connector Colors
" section on page 119 for important information about Rear
FSN-1004 • User's Guide • Rev 00
Advertisement
Table of Contents
