Barco FSN-1004 User Manual page 139

oÉ~ê=fLl=sáÉï=aÉëÅêáéíáçå
The Rear I/O View for the Out Setup Menu shows the I/O panels for output slots 8 , 11 , 12
and 13 . This view matches your system configuration exactly — based on the installed
cards. Please note:
•
•
•
•
•
•
^ìñ=q~ÄäÉ=aÉëÅêáéíáçå
The figure below illustrates a portion of the Out Setup Table on the Out Setup Menu :
Figure 4-67. Out Setup Table (sample)
The Out Setup Table provides information about each Aux output, and the yellow highlight
automatically tracks the selected Aux connector in the Rear I/O View . Because more than
16 Aux outputs can be installed (and because the table is only 16 rows in length), the table
automatically scrolls as required.
The following columns of information are provided:
•
•
FSN-1004 • User's Guide • Rev 00
The number of each slot is shown along the top.
Only Aux output connectors will be active in the view — all other connectors will
be grayed out, including those on the Multiviewers.
The type of each installed card is shown along the bottom (e.g., SOC ).
If a card is not installed, the label " Not Installed " appears in the slot.
To set up an Aux output on the M/E card, press the desired connector on the M/E
card. The yellow border indicates that the connector is selected, and in the Out
Setup Table , the output row is automatically highlighted.
To set up a universal output on a SOC , press any of the top three connectors to
select Output 1 , or any of the bottom three connectors to select Output 2 . The
selected output is highlighted with a yellow border around all three connectors.
Note SOC connectors that are not outputting video will be grayed
out (e.g., for an un-supported video format).
Slot — indicates the selected card slot ( 8 , 11 , 12 or 13 ).
Out — indicates the selected Aux output:
~
1 through 6 on the M/E card.
~
1 or 2 for a SOC .
4. Menu Orientation
System Menu
139