Table of Contents
Advertisement
5. System Setup
Power Up and Status Check
mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ
FSN-1004 system setup: Step 1 .
Use the following steps to power up your system and check system status.
1
1.
2.
3.
4.
166
Prerequisite — Ensure that your system is properly installed and cabled. In
Chapter 3, refer to the following sections for details:
~
"
PC Connection
~
"
System Connections
Prerequisite — Ensure that you are familiar with the System Menu . In
Chapter 4, refer to the "
complete details.
Power up the FSN-1004 switcher.
Launch the FSN-1004 GUI. The System Menu is automatically displayed after
boot up. If the system is not set up as an FSN-1004, a message says "Do you
want to set up as FSN-1004?". If you answer "Yes", setup occurs; if you answer
"No", the setup program exits.
Important
If communication is not properly set up, numerous buttons will
be grayed out on the System Menu . These buttons will
activate once communication is properly set.
Power up all additional peripherals, such as monitors and sources.
On the System Menu :
~
In the System Status Table , ensure that all devices are connected. If
not, re-check all Ethernet connections. After checking connections, if
devices still report " Not Connected ," use the "
procedure on page 168.
~
Ensure that the software versions for the GUI and FSN-1004 match. If
not, you may need to update GUI software or match the FSN-1004's
software to the installed GUI software. Refer to Chapter 8, "
Software
" on page 215 for details.
Note
If the software versions on the GUI and FSN-1004 match, you
do not need to upgrade.
~
In the FSN-1004 Status Table , ensure that all installed UIC , SOC and
MVR cards are recognized. If not, you may need to re-seat the boards in
the FSN-1004.
," page 52.
," page 55.
System Menu Description
FSN-1004 • User's Guide • Rev 00
" section on page 108 for
Communications Setup
"
Updating
Advertisement
Table of Contents
