Table of Contents
Advertisement
Mounting the access point using the Main Mounting
Bracket with KT-135628-01 adaptor to a flat T-bar
4. Replace the ceiling tiles.
5. Attach the Ethernet cable's RJ45 connector to the LAN1 port.
Mounting the access point using the Main Mounting Bracket with KT-135628-01
adaptor to a flat T-bar
About This Task
Mounting the access point to a suspended or a drop ceiling requires the optional
adaptor (Universal Mounting Kit for WLAN APs; # KT- 135628-01). The adaptor requires a
flat t-bar and fits a ceiling tile with up to a 0.35" protrusion from the bar.
Pre-Installation checklist:
•
T-bar width can be either 9/16" (15 mm) or 15/16" (24 mm).
•
T-bar bottom must be flat all the way across.
•
T-bar minimum base thickness: N/A; must be structurally sound.
•
T-bar maximum base thickness: 0.055". Due to manufacturing variation, some
adaptors may be able to accommodate up to 0.060".
•
Ceiling tile may protrude up to 0.3" below the T-bar.
Procedure
1. Attach the KT- 135628-01 adaptor by lining up the small bends on the adaptor with
the long raised parts on the main bracket, pull up on the adaptor's locking pin, and
twist.
Make sure the locking pin goes into the locking pin hole on the main mounting
bracket and locks in place.
2. Slide the T-bar holder onto the T-bar and replace the tiles to hold the adaptor onto
the T-bar.
3. Hold the access point and rock it back and forth to ensure that it is securely
mounted.
4. Attach the Ethernet cable's RJ45 connector to the LAN1 port.
Mounting the access point using the WS-MBI-DCFLUSH Bracket to a flat T-bar
About This Task
The optional WS-MBI-DCFLUSH (#37211) bracket is used for T-bar installations without
the main mounting bracket.
Pre-Installation checklist:
•
T-bar width must be 9/16" (15 mm), 15/16" (24mm), 1.5" (38 mm).
•
T-bar bottom must be flat all the way across.
•
T-bar minimum base thickness: N/A; must be structurally sound.
•
T-bar maximum base thickness is 0.080" (2mm).
•
Ceiling tile must be flat all the way across.
•
Maximum ceiling tile protrusion allowed is 0.015" (0.38 mm).
30
ExtremeWireless™ AP510e
Install the Access Point
Advertisement
Table of Contents
