Extreme Networks ExtremeWireless AP510e Installation Manual page 25

Install the Access Point
Procedure
1. Install the WS-MBI-WALL04 bracket on a wall or to a flat ceiling with the two screws
and screw-in anchors. Ensure that the locking tab on the WS-MBI-WALL04 bracket
is on the top side during installation.
Figure 9: Mounting the access point using the WS-MBI-WALL04 bracket
•
Use the WS-MBI-WALL04 as a template and mark the holes to be used to mount
the access point. The recommended holes are marked "A" or "B".
•
Drill the holes and attach the bracket using the screws and screw-in anchors.
Note
When using the "A" or "B" holes, if the holes are not near the corners of the
bracket, you can break off the corner to decrease the bracket's visibility once
the access point is installed.
Mount the AP to a wall using the WS-MBI-WALL04
ExtremeWireless™ AP510e
bracket
25