Mount The Access Point To A Wall Using The Phillips Pan-Head Screws - Extreme Networks ExtremeWireless AP510e Installation Manual

Mount the access point to a wall using the Phillips pan-
head screws
5. Connect the LAN cable to the back of the access point.
6. Hold the access point to the wall, insert the two screws onto the mounting holes of
the flat metal easy-attach adaptor.
7. Tighten the two screws until you lock it into place.

Mount the access point to a wall using the Phillips pan-head screws

About This Task
You can mount the access point directly onto a dry or a solid wall using the Phillips
pan-head screws. This is an optional installation method and not the preferred method
of installation.
Procedure
1. Drill two holes 104 mm (4.100") apart from each other on the wall where you want to
mount the access point.
2. Insert the screws into the holes and use the screw-in anchors, if needed.
Figure 12: Mounting the access point directly on a dry or a wood wall using the
Phillips pan-head screws
3. Insert the Ethernet cable's RJ45 connector into the Console port.
28 ExtremeWireless™ AP510e
Install the Access Point