Mounting The Ap Using The Ws-Mbi-Dcmtr01 Bracket - Extreme Networks ExtremeWireless AP510e Installation Manual

Mounting the AP using the WS-MBI-DCMTR01 Bracket

6. Slide the T-bar ceiling mount bracket base into the back of the access point.
The locking tab fits into a groove in the outside of the access point.
Figure 14: Attaching the DCFLUSH bracket to the access point
7. Hold the access point and rock it back and forth to ensure that it is securely
mounted.
8. Attach the Ethernet cable's RJ45 connector to the LAN1 port.
9. Place the ceiling tile back in place.
Mounting the AP using the WS-MBI-DCMTR01 Bracket
About This Task
The optional WS-MBI-DCMTR01 (#30518) bracket is used for T-bar installations without
the main mounting bracket.
Pre-Installation checklist:
•
T-bar width must be 9/16" (15 mm), 15/16" (24 mm), 1.5" (38 mm).
•
T-bar minimum base thickness: N/A; must be structurally sound.
•
T-bar maximum base thickness is 0.118" (3 mm).
•
T-bar can have a maximum protrusion of 0.625" (15.8 mm).
•
Maximum protrusion of the ceiling tile can be 0.625" (15.8 mm).
32 ExtremeWireless™ AP510e
Install the Access Point