Mount the AP to a wall using the WS-MBI-WALL04
bracket
Procedure
1. Line up the security torx locking screw using the rear guides on the access point.
2. Using a T10 bit screwdriver, tighten the security torx locking screw.
3. Turn the locking screw into the security screw hole until the security torx locking
screw passes through to the other side and touches the screw stop feature.
Figure 8: Security torx locking screw stop feature
Callout
1
Mount the AP to a wall using the WS-MBI-WALL04 bracket
About This Task
Mounting the access point to a flat ceiling requires the WS-MBI-WALL04 (#30516)
bracket, two Philips pan-head screws, and two screw-in anchors.
24
ExtremeWireless™ AP510e
Description
Security torx locking screw stop feature
Note
You cannot remove the access point from the main mounting bracket until
the security torx locking screw is removed.
Install the Access Point