Table of Contents
Advertisement
Install the Access Point
2. Line up the #37201 main mounting bracket holes on the junction/gang box and
ensure that they align.
If the holes do not align, then use the WS-MBI-WALL04 bracket.
3. Using the holes aligned together or the new ones drilled, attach the bracket to the
junction/gang box using the screws removed from the junction box earlier.
Do not over tighten.
4. Connect the Ethernet cable to the access point.
5. Align the keyhole slots and posts and slide the access point onto the bracket until
you hear it lock in place.
Mount the access point to a Beam
About This Task
The access point can be mounted onto a beam using a beam clip accessory
(BRKT-000147A-01) to the main mounting bracket.
Pre-Installation checklist:
•
The beam must be able to support the access point in all environmental conditions.
•
The beam should be flat.
Before attaching the AP onto a beam, verify that:
•
Beam attachment area is at least 0.5" (12.7 mm) wide and as long as the access
point's largest dimension.
•
Beam mounting surface is less than 0.650" (16.5 mm) thick.
Note
When you line up the holes, the locking tab on the WALL04 bracket must
be pointing up and the junction/gang box must be fully covered by the
bracket. The bracket must be square to the rest of the room walls and the
two holes that are being used must be on the opposite side of large center
hole on the WALL04 bracket.
Note
If the holes that you need to use are not near the corners of the WALL04
bracket, break off the corner to decrease bracket's visibility once the access
point is installed.
Caution
Over tightening the screws will cause the WALL04 bracket to bend. If the
bracket bends, you will not be able to align and slide the access point onto
the keyhole posts.
Mount the access point to a Beam
ExtremeWireless™ AP510e
35
Advertisement
Table of Contents
