Table of Contents
Advertisement
Power Supplies for Use with Your
Switch
Each 7520 Series switch runs with two replaceable internal power supply modules that
provide all of the power needed for the switch to operate. You can remove one power
supply module without interrupting the switch's operation. Supported power supply
configurations include two 800 W AC power supply modules, two 800 W DC power
supply modules, or one 800 W AC and one 800 W DC power supply module. Power
supply modules have integrated cooling fans that operate independently of the switch
fans, and are available with front-to-back or back-to-front airflow. The direction of the
airflow in both power supply modules must be in the same direction, and must also be
the in same direction of the airflow in the fan modules.
Power supply modules are ordered separately for base models 7520-48Y-8C and
7520-48XT-6C. Power supply modules are included with other models.
Precautions Specific to Power Supply Modules
Warning
Make sure that the power source circuits are properly grounded, then use the
power cord supplied with the device to connect it to the power source.
Warning
If the installation requires a different power cord than the one supplied with
the device, make sure you use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the device.
Caution
Disassembling any part of the power supply and fan assembly voids the
warranty and regulatory certifications. There are no user-serviceable parts
inside the power supply and fan assembly.
Caution
Ensure that the airflow direction of the power supply unit matches that of
the installed fan tray. The power supplies and fan trays are clearly labeled with
either a green arrow with an "E", or an orange arrow with an "I."
18
Extreme 7520 Hardware Installation Guide
Advertisement
Table of Contents
