Extreme Networks ExtremeWireless AP510e Installation Manual page 39

Install the Access Point
For best results, mount the antenna in the center of the coverage area. A line-of-sight
path between the antenna and the active area works best. Avoid mounting next to a
column or vertical support that creates a shadow zone and reduces coverage.
Note
Install the antenna before you connect the cable so the cable is not twisted or
damaged.
Procedure
1. Attach the antenna mount to the exposed studs on the back of the antenna with
four 1/4 in -20 hex nuts, four 1/4 in-20 flat washers, and four 1/4 in -20 lock washers.
2. Secure one side of the articulating arm to the antenna mount using one bolt size
5/16 in x 1-5/8 in (5), 1 5-16 in split lock wash, and two flat washer 5-16 in and one hex
nut 5-16.
3. Mount the antenna on a wall:
a. Mark holes locations.
Use the other supplied antenna mount bracket as a template.
b. Install four wall expansion anchors.
c. Install the antenna mount bracket to the wall.
Use four the hex 1/4-20 screws, four 1/4-20 flat washers, and four 1/4-20 lock
washers.
4. (Optional) Mount the antenna on a pole or mast:
a. Attach the two hose clamps to the antenna mount bracket.
You can encircle the pole with each clamp. Tighten the clamps securely.
5. Attach the pre-assembled antenna to the other bracket.
Use one external serrated washer, use one bolt size 5/16 in -1 5/8 in, one 5-16 in split
lock washer, two flat washer 5-16 in and one hex nut 5-16 in.
Use the screw to attach the free end of the articulating arm to the mount and then
secure it in place with a hex nut.
6. Adjust the antenna for azimuth and elevation.
a. Loosen the 1-5/8 in bolt pivot screw.
b. Adjust the antenna for azimuth and elevation.
c. Tighten the hardware securely.
Install the AIO-DQ15021-RPSMA Antenna
ExtremeWireless™ AP510e 39