Table of Contents
Advertisement
Mount the access point to a wall using the Main
Mounting Bracket
Mount the access point to a wall using the Main Mounting Bracket
About This Task
The stainless-steel main mounting bracket (#37201) ships with the access point and can
be used to mount the access point onto a wall. This is the recommended method of
installation for a wall mounting procedure.
Procedure
1. Using the main mounting bracket as a template, mark the hole centers on the wall.
Figure 5: Main mounting bracket direction with hole centers
2. Drill two holes 83 mm (3.270") apart from each other on the wall where you want to
mount the access point.
20
ExtremeWireless™ AP510e
Note
The four feet of the bracket and the direction of the arrow mark on the
bracket must be pointing up. The flat part of the bracket must be touching
the surface it is being attached to.
Install the Access Point
Advertisement
Table of Contents
