Mount The Ap To A Junction/Gang Box - Extreme Networks ExtremeWireless AP510e Installation Manual

Mount the AP to a Junction/Gang box

6. Slide the T-bar ceiling mount bracket base into the back of the access point.
The locking tab fits into a groove in the outside of the access point.
Figure 16: Attaching the access point onto the WS-MBI-DCMTR01 bracket
7. Hold the access point and rock it back and forth to ensure that it is securely
mounted.
8. Attach the Ethernet cable's RJ45 connector to the LAN1 port and place the ceiling
tile back in place.
Mount the AP to a Junction/Gang box
About This Task
You can mount the access point to a junction/gang box using the #37201 stainless-steel
main mounting bracket that comes with the unit or a WS-MBI-WALL04 bracket, which
must be purchased separately.
Note
The junction/gang box models are limited to USA box models when using the
#37201 main mounting bracket.
Procedure
1. Remove the screws holding the junction/gang box coverplate and remove the LAN
cable from the coverplate if necessary.
34 ExtremeWireless™ AP510e
Install the Access Point