Table of Contents
Advertisement
OM3006.3 04/98
Instrument Panel and Indicators
R.H. Control/Indicator Panel (Pod)
The Control/Indicator Panel (3, Figure 3-6), located to
the right of the steering wheel, provides an array of
switches and controls.
For detailed inrormation on this assembly, refer to
''R.H. Control/Indicator Panel (Pod)'' later in this sec-
tion.
Center Display Panel
The Center Display Panel (4, Figure 3-6) provides an
array of gauges and monitors, with an odometer mod-
ule) and a service/hour meter module.
For detailed inrormation on this assembly, refer to
''Center Display Panel'' later in this section.
L.H. Control/Indicator Panel (Pod)
The Control/Indicator Panel (5, Figure 3-6), located to
the left of the steering wheel, provides an array of
indicator/monitor lights and three switches.
For detailed inrormation on this assembly, refer to ''L.H.
Control/Indicator Panel (Pod)'' later in this section.
Ladder Light Switch
The switch (6, Figure 3-6) turns the
ladder lights ''On'' or ''Off'' after or
before using ladder. A similar
switch is available at ground level to
turn the lader lights ''Off'' or ''On''.
Head Light Switch
The instrument panel lights, clear-
ance lights, and the headlights are
controlled by this three position
rocker type switch (7, Figure 3-6).
''Off'' is selected by pressing the left
side of the switch. Press the right
side of the switch until it reaches the
first detent (middle) to select the
panel, clearance, and tail lights only. Press the right
side of the switch again, until it reaches the second
detent to select headlights, as well as panel, clearance,
and tail lights.
"OFF"
These are ''Rocker-type'' switches.
The ''Off'' and ''On'' positions are
marked with these symbols.
BackUp/Deck Lights Switch
The BackUp/Deck Lights Switch (8,
Figure 3-6) allows backup lights to
be turned ''On'' providing added
visibility and safety when the Trans-
mission Range Selector lever (see
OPERATOR CONTROLS) is not in
''REV'' position.
Mode Change Switches
The Mode Change Switches (9 & 10, Figure 3-6) are to
be used only by qualified service technicians.
Operation - Section 3
Page 3-23
"ON"
Advertisement
Table of Contents
