Komatsu 530M Operation & Maintenance Manual page 133

Optional Equipment - Section 6
Page 6-18
9. Press the LIGHT/INC switch to change the first
digit to the desired number.
10. Press the MODE switch to return to normal op-
eration.
Setting The Operator I.D. Code
1. Press and hold the MODE switch
until "Cd:dP" is displayed.
2. Press the MODE switch once. The
display will show:
3. Press the MODE switch once. The
display will show:
4. Press the MODE switch repeatedly
until "o.XXX" is displayed.
5. Press the LIGHT/INC switch to change the last
digit to the desired number.
6. Press the TOTAL/SFT switch and
the display will then indicate:
7. Press the LIGHT/INC switch to change the middle
digit to the desired number.
8. Press the TOTAL/SFT switch and
the display will show:
9. Press the LIGHT/INC switch to change the first
digit to the desired number.
10. Press the MODE switch to return to normal op-
eration.
Setting The Time and Date
1. Press and hold the MODE switch
until "Cd:dP" is displayed.
2. Press the MODE switch once. The
display will show:
3. Press the MODE switch once. The
display will show:
4. Press the MODE switch repeatedly
until "XX:XX" is displayed.
5. Press the LIGHT/INC switch to change the min-
utes.
6. Press the TOTAL/SFT switch and
the display will then indicate:
7. Press the LIGHT/INC switch to change the hours.
The clock is a 24 hour clock.
8. Press the TOTAL/SFT switch and
the display will then indicate:
9. Press the LIGHT/INC switch to change the day.
10. Press the TOTAL/SFT switch and
the display will then indicate:
11. Press the LIGHT/INC switch to change the month.
12. Press the TOTAL/SFT switch and
the display will then indicate:
13. Press the LIGHT/INC switch to change the year.
14.Press the MODE switch to return to normal opera-
tion.
DOWNLOAD OF INFORMATION
Payload information and fault codes recorded should
be downloaded to a personal computer on a regular
basis. The software required is available under part
number AK4094. Detailed instructions for installing the
software and downloading the data is provided with
AK4094 PLM II download software.
Data All Clear
This function will erase all of the cycle data, engine
ON/OFF data, and fault/warning data. Total payload
and the overall number of cycles will not be cleared.
IMPORTANT - Before clearing the data, download
the data to a personal computer.
To begin, the shift lever should be in the ''N''
position, the brake lock set, the hoist control lever
should be in the ''FLOAT'' position and the body in
the down position.
1. Press and hold the MODE switch
until "Cd:dP" is displayed.
2. Press the MODE switch once. The
display will show:
3. Press and hold the CAL/CLR
switch until "A.CLE" is flashing.
4. Press the CAL/CLR switch again and the memory
will be cleared. The meter will then return to
normal operation.
This does not clear the Operator Load Counter.
OM6007 2/99
Payload Meter II