Komatsu 530M Operation & Maintenance Manual page 93

Maintenance - Section 4
Page 4-8
1000 HOUR SERVICE
In addition to the 250 and 500 hour lubrication and
inspection schedules, perform the following:
1. LUBRICATING
- Transmission mount - 1 point. - Lube key ''D''.
- Parking brake linkage - 6 point - Lube key ''D''.
2. TRANSMISSION CASE
Drain oil, remove and replace element. Remove
clean, and reinstall strainer. Refill tank with oil
approximate 40.5 gal (153 l).
Refer to ''Lubrication Chart'' for fuel, coolant and
lubricants and type of oil to use. Lube key ''C''.
3. STEERING, BRAKE, HOIST, and REAR BRAKE
COOLING OIL FILTERS.
When removing tank caps, turn cap slowly at first
to relieve inner pressure. Remove cap only after
pressure has been completely relieved.
Any operating fluid, such as hydraulic oil or brake
fluid escaping under pressure, can have sufficient
force to enter a person's body by penetrating the
skin. Serious injury and possibly death may result
if proper medical treatment by a physician familiar
with this injury is not received immediately.
Remove & replace (4) filter elements.
Refer to ''Hydraulic Tank Service'', page 4-10.
4. FRONT & REAR BRAKE WEAR -
Refer to shop manual Section ''J'', Brake System,
for proper inspection procedure.
Carry out inspection when the oil temperature is
below 60°C (140°F ).
Hot oil may cause serious personal injury.
Truck Serial Number ____________________________
Site Unit Number ______________________________
Date:______________Hour Meter_________________
Serviceperson Name___________________________
COMMENTS
OM4006.1 06/98
Lubrication and Service
√'d
INITIALS