Komatsu 530M Operation & Maintenance Manual page 90

OM4006.1 06/98
Lubrication and Service
INITIAL 250 HOURS SERVICE
Perform the following maintenance after running the
machine for the first 250 hours.
Thereafter, these services are to be accomplished at
the 1000/2000 hour interval as scheduled.
Refer to pages 4-8, -9, & -10.
a. Fuel Filter, replace cartridges.
b. Transmission - change oil and filter elements.
c. Steering & Brake Oil Tank - change oil and filter
elements.
d. Hoist & Brake Cooling Oil Tank - change oil and
filter elements.
e. Differential Case, change oil.
f. Final Drive Case, change oil.
EVERY 250 HOURS SERVICE
1. Lubrication -
Check automatic lube system to be sure ample
grease supply is reaching pins and bearings.
- Dump body hinge pin - 2 points.
- Rear Suspension - 4 points.
- Axle Supports pins - 8 points.
- Hoist Cylinder pin - 4 points.
- Front Suspension Assembly - 8 points.
- Steering Cylinder pin - 4 points.
- Steering Linkage - 5 points.
- Drive Shafts -
Front, 2 points; Rear, 3 points.
Refill grease reservoir - Use lube key ''D''.
(Reservoir Capacity is approximately 7.7 gal. or
60 lbs [27kg] of grease.)
2. BATTERY - Check electrolyte level and add distilled
water if necessary to maintain proper level.
3. ENGINE - Refer to engine manufacture's service
manual for oil recommendations and capacity.
- change engine oil.
- change engine lube oil filter.
250 HOURS SERVICE
Truck Serial Number ____________________________
Site Unit Number _____________________________
Date:______________Hour Meter_________________
Serviceperson Name___________________________
Maintenance - Section 4
√'d
COMMENTS
Page 4-5
INITIALS