Komatsu 530M Operation & Maintenance Manual page 126

OM6007 2/99
Payload Meter II
Engine Operation
ITEM
Number when Canceled
Last Two Digits Of Year
Month
Day
Time Hour
Time Minute
NOTE: If the engine operation number is a 0, this indicates that the problem occurred or was canceled (depends on
the operation that was performed) when the key switch was in the ON position and the engine was not running.
Total Payload and Total Number of Cycles
The total payload and overall number of cycles can be displayed using the forced display operation. Both values
start from a zero point whenever the memory has been cleared. The payload total is automatically displayed when
the load is dumped.
ITEM
Total Payload
Total Number Of Cycles
Last Two Digits Of Year
Month
Day
Time Hour
Time Minute
Other Data
CONTENT
Set Up Data That The Speed Limit
Operator Can Check
Option Code
Year
Month
Calibration Data
Day
Hour
Minute
UNIT
Number
Year
Month
Day
Hour
Minute
UNIT
Metric Tons
Short Tons
Digital Number
Year
Month
Day
Hour
Minute
ITEM UNIT
Km/MPH
Digital Number
Year
Month
Day
Hour
Minute
Optional Equipment - Section 6
RANGE
Every time the engine is started
1 - 65535
the number advances by one.
0 - 99
1 - 12
1 - 31
24 Hour Clock
0 - 59
RANGE
The total payload since the unit
0 - 999900.0
was cleared.
The number of cycles since the
0 - 9999
unit was cleared.
0 - 99
1 - 12
Date and time the unit was
1 - 31
cleared.
24 Hour Clock
0 - 59
RANGE
0 - 99
0 - 13 Communication Mode
0 - 99
1 - 12
Date and time when calibrated.
1 - 31
24 Hour Clock
0 - 59
Page 6-11
REMARKS
REMARKS
REMARKS