Komatsu 530M Operation & Maintenance Manual page 137

Optional Equipment - Section 6
Page 6-22
Monitoring Input Signals
This procedure can be used to monitor the current
input signals to the payload meter.
1. Press and hold the LIGHT/INC and MODE
switches until "CHEC" is flashing.
2. Press and hold the CAL/CLR and TOTAL/SFT
switches until "S.CHE" is flashing.
3. Press the CAL/CLR switch to cycle through the
following information :
C1 Mechanical Trucks
C1 Electric Trucks
C2 Body Up
C3 Engine Oil Pressure
C4 Alternator R Terminal
C5 Analog 1 - Not Used
C6 Analog 2 - Not Used
C7 Digital 1 - Not Used
C8 Digital 2 - Not Used
C9 Speed
Travel Distance -
C10 under the current
loaded or empty state
Current Status
Note:
C11
Sample values are
shown.
C12(a)* Time Empty Travel
C12(b) Time Empty Stopped S2:xx - Minutes*10
C12(c) Time Loaded Travel S3:xx - Minutes*10
C12(d) Time Loaded Stop
C12(e) Time Dumping
C12(f) Time Loading
* After 9.9 minutes, "S1:--" will be displayed.
4. Press the MODE switch once and "CHEC" will
flash.
5. Press the MODE switch once and the meter will
return to normal operation.
C1:oo - Shift Selector in "N"
C1:-- - Shift Selector
not in "N"
C1:oo - Brake Lock On
C1:-- - Brake Lock Off
C2:oo - Body Down
C2:-- - Body Up
C3:oo - Engine Run
C3:-- - Engine Stopped
C4:oo -Alternator Charging
C4:-- - Alternator Stopped
Vehicle Speed
xx.xx Miles
03:01 - Empty Stopped
01:02 - Empty Traveling
06:03 - Loading
02:04 - Loaded Traveling
04:05 - Loaded Stopped
05:06 - Dumping
S1:xx - Minutes*10
S4:xx - Minutes*10
S5:xx - Minutes*10
S6:xx - Minutes*10
Service Check Mode
1. Press and hold the LIGHT/INC and MODE
switches until "CHEC" is flashing.
2. Press and hold the LIGHT/INC switch until "ALL0"
is flashing. "A.FUL" may also be displayed.
3. Press the LIGHT/INC switch to cycle through the
following data. The sequence repeats.
Item and Description
1. Current Time
2. Pressure Front Left
3. Pressure Front Right
4. Pressure Rear Left
5. Pressure Rear Right
6. Front Weight
7. Rear Weight
8. Degree of Incline
9. Incline Factor - Front Axle
10. Incline Factor - Rear Axle
11. Link Factor - Front Axle
12. Link Factor - Rear Axle
13. Calibration Weight
14. Gt - Trimmer Gain
15. Current Load
16. Backup Battery Voltage
4. Press MODE once and "CHEC" will flash on the
display.
5. Press MODE once and the meter will return to
normal operation.
OM6007 2/99
Payload Meter II
Units
Hours:Minutes
Psi
Psi
Psi
Psi
Tons
Tons
±°
Nose Up
Positive
Tons
Tons
Volts