Table of Contents
Advertisement
OM6007 2/99
Payload Meter II
Calibrating a Truck
The payload meter should be calibrated whenever one
of the following occurs:
1. When a new payload meter is installed.
2. When a suspension sensor has been changed.
3. Whenever the suspensions have been serviced
or the Nitrogen levels have changed.
4. Once a month thereafter.
To calibrate the payload meter:
1. With the engine running and the truck stopped,
press and hold the CAL/CLR switch until "CAL" is
flashing on the display.
2. Drive the truck until the speed is approximately
6-10 MPH (10-15 Km/H)
3. Press the CAL/CLR switch once.
4. Drive until the display switches back to the time
of day. This will take up to 30 seconds.
5. The payload meter is now calibrated and ready
for normal operation.
Carry out this operation on flat level ground.
Travel in a straight line.
Maintain a steady speed, 6-10 MPH (10-15 Km/H)
Optional Equipment - Section 6
Page 6-15
Advertisement
Table of Contents
