Table of Contents
Advertisement
Safety - Section 2
Page 2-20
A plate attached to the right rear corner of the cab states the Rollover Protective Structure and Falling Object Protective
Structure meets various SAE performance requirements.
! WARNING !
Do not make modifications to this structure, or attempt to repair damage without
written approval from the Manufacturer.
Unauthorized repairs will void certification.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DANGER plates are mounted on each suspension and
accumulator cylinder. These plates warn that the sus-
pensions and accumulators are charged with high
pressure nitrogen. No servicing of any kind should be
attempted until the service manual has been refer-
enced and proper and safe procedures are followed.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warning plates are attached to both the hydraulic tank
and fuel tank to alert technicians not to work on the
truck with the body in the raised position unless
body-up retention device (pins or cable) is in position.
OM2006.2 6/98
Warnings and Cautions
Advertisement
Table of Contents
