Komatsu 530M Operation & Maintenance Manual page 123

Optional Equipment - Section 6
Page 6-8
In order to adjust this gain:
1. Start with the payload meter in normal operation
mode.
2. Adjust the gain pot, left to reduce the value and
right to increase the value.
3. Press and hold the LIGHT/INC and
MODE switches until "CHEC" is
flashing on the meter.
4. Press and hold the LIGHT/INC
switch until "ALL0" is flashing on
the display. "A.FUL" may also be displayed.
5. Press the LIGHT/INC switch14 times. The number
displayed will be the current Gt gain. This is not a
"live" reading. Any time the potentiometer is
changed, this cycle must be repeated to view the
change.
6. Press MODE once and "CHEC" will
flash on the display.
7. Press MODE once and the meter will return to
normal operation.
These calculations used a 13" front suspension diame-
ter and 10" rear suspension diameter.
π
Sprung Weight = Suspension Diameter
4
Sprung Weight = Axle Weight(lbs)/2000
Example Calculation of Payload
Front Weight (6) 106.00 Rear Weight(7)
X Incline Factor (9) 0.95 X Incline Factor (10) 0.98
100.70
X Link Factor (11) 1.00 X Link Factor (12)
Front Weight 100.70 Rear Weight
Front Weight 100.70
Rear Weight 113.70
Total Weight 214.40
XGain Factor (14)
1.00
214.40
- Calibration (13) -70.60
Current Load(15) 143.80
Figure 6-5.
2
(Psi Left + Psi Right)
75.10
73.90
1.53
113.70
Calculation of the Calibration Load
This procedure is similar to the manual calculation of
load. This calibration load is used as item #13 from the
manual calculation procedure.
1. Press and hold the LIGHT/INC and MODE
switches until
"CHEC" is flashing on the display.
2. Press and hold the CAL/CLR
switch until "CALL0" is flashing on
the display.
3. Press the CAL/CLR switch to cycle through the
following data. The sequence repeats.
Item and Description
1. Year of Calibration
2. Month:Day of Calibration
3. Hour:Minute of Calibration XX:XX
4. Truck Model Setting
5. Pressure Front Left
6. Pressure Front Right
7. Pressure Rear Left
8. Pressure Rear Right
9. Front Sprung Weight
10. Rear Sprung Weight
11. Degree of Incline
12. Incline Factor - Front Axle
13. Incline Factor - Rear Axle
14. Link Factor Front Axle
15.Link Factor Rear Axle
16. Calibration Weight
4. Press MODE once and
"CHEC" will flash on the display.
5. Press MODE once and the meter will return to
normal operation.
OM6007 2/99
Payload Meter II
Units
Last 2 digits of year
XX:XX
Psi
Psi
Psi
Psi
Tons
Tons
±° Nose Up Positive
Tons