Table of Contents
Advertisement
The RAID Configuration Utility (RCU) need only be run if a KZPSC con-
troller is in the system. The controller comes with its own documentation
describing the utility. The controller can operate in several different
modes, and the customer should determine how to customize the disk
farm. RCU enables the choices. Prior to running the utility, you should
read the documentation and discuss which mode the customer wishes. Ex-
ample 7-5 shows how to run RCU.
Place the RAID Configuration Utility floppy in the floppy drive.
Use the set command to turn on the arc_enable environment vari-
1
able.
Initialize the system to make the set command take effect.
2
After self-test completes, enter run rcu to identify what program to
3
run. The run command defaults to the floppy as the source of the pro-
gram for execution so no device need be specified.
-p 1 specifies that PCI1 is to be configured. See Example 7-2 for the
4
PCI number containing the KZPSC (shown by the console as the
DAC960). (In this case it is connected to a KFTIA hose.)
Diagnostics and Utilities 7-17
Advertisement
Table of Contents
