Table of Contents
Advertisement
1.
Check that the receptacle provided is correct. This should have been
done during site preparation.
2.
Using a voltmeter, measure the voltages between lines in the recepta-
cle as shown in Figure 5-2. Verify that the voltages are within the
range specified in Table 5-1. If the voltages are out of range, contact
an electrician.
3.
Plug the power cord into the receptacle.
Table 5-1 AC Input Voltage Specifications
Voltage
208V
Measurement
Nominal
208
line to line
120
line to ground
(Phase 1 to GND)
NA
neutral to ground
220/240V
Nominal
220–240
220–240
0
Powering Up the System 5-5
Advertisement
Table of Contents
