Color Processing; Color Replacement - NovaStar CX40 Pro User Manual

Figure 6-12 Editing layer

Status: Turn on or off the layer.

Input: Select an input source.
On the home screen, the number of the layer that is using this input source is displayed in the input source
information area.

Scaling Mode: Set the scaling mode.
−
Custom: Customize the width and height.
−
Pixel to Pixel: The layer width and height are the same as the input source.
−
Snap to Canvas: The layer width and height are the same as the canvas size.

Width: Set the layer width.

Height: Set the layer height.

H Position: Set the horizontal coordinate (X) of the layer on the canvas.

V Position: Set the vertical coordinate (Y) of the layer on the canvas.

Priority: Set the Z coordinate of the layer on the canvas. The greater the value, the higher priority.

Input Crop: Turn on or off input crop and set the crop size and position.

Border: Turn on or off layer border and set the border thickness and color.
If necessary, select other layers and set the related parameters.

6.6 Color Processing

This chapter describes color processing with one device selected. You can perform any of the following operations as
required.

6.6.1 Color Replacement

Replace one color with another color according to the specified settings.
This function only has an on/off switch on the CX40 Pro. You need to follow the steps below to set the specific
parameters in VMP.
Note
Replacement of highly saturated colors is recommended for better effect.
Run VMP and connect devices.
Select Processing.
Set the Color Replacement switch to
www.novastar.tech
CX40 Pro LED Display Controller User Manual
.
22