Set An Ip Address; Factory Reset - NovaStar CX40 Pro User Manual

Figure 7-3 Diagnostics
Select Yes in the displayed dialog box.
After successful diagnostics, do any of the following as required.

Check the diagnostic result
Check the diagnostic result report, including the supply voltages of the MCU, FPGA and motherboard, the
temperature inside the chassis, and other information.

Export the diagnostic result to a USB drive
a.
Insert the USB drive to the USB port on the front panel of the device.
b.
Select Export.
A prompt will be displayed after the operation is successful.

7.3 Set an IP Address

Manually set a static IP address for the device or set up the device to automatically obtain an IP address.
On the main menu screen, select Network.
Figure 7-4 Network settings
Choose whether to enable Obtain Automatically.

Enable: The device automatically obtains the IP address.

Disable: Manually set a static IP address for the device.
If Obtain Automatically is disabled, set an IP Address, Subnet Mask and Default Gateway and select Apply. If
Obtain Automatically is enabled, this step is not required.
If you want to reset the IP address to the default, select Default.

7.4 Factory Reset

Reset part or all of the device data to the factory settings.
On the main menu screen, choose Settings > Factory Reset.
www.novastar.tech
CX40 Pro LED Display Controller User Manual
30