Enable 3D Lut - NovaStar CX40 Pro User Manual

CX40 Pro LED Display Controller User Manual
Figure 6-16 Curves Adjustment
Select the white, red, green or blue channel.
Drag the slider under the curve diagram to set the curve adjustment range.
Click on any position of the curve to add an adjustment point and drag the point to adjust the curve.
Input and Output indicate the absolute coordinates of the adjustment point in the curve diagram.
To delete the adjustment point, drag the point outside the curve diagram, or select the point and press Delete.
After the parameter setting is complete, you can select Processing on the device main menu screen and select
Curves to perform the on/off operation.
Figure 6-17 Curves

6.6.4 Enable 3D LUT

A set of mapping relationships are defined in the 3D LUT file (.cube) to adjust the colors of the video source. Before
the operation, you need to upload a 17×17×17 3D LUT .cube file in VMP.
Run VMP and connect devices.
Select Processing.
Click anywhere in the Load 3DLUT file area, select a file and open it.
www.novastar.tech 25