NovaStar CX40 Pro User Manual page 15

In the device list on the left, select the desired controller.
From the menu bar, choose View > Display, select a view for the topology area, and select the content to be
displayed.
You can also select a view by clicking one of the following icons at top right of the topology area. The selected view
will have a green spot near it.

: Show the cabinets only.

: Show the preview image of the input source only.

: Show the cabinets and preview image of the input source at the same time.
In addition, you can choose to show the cabinet topology, cabinet status, group names, source tags, and overlapping
cabinets.
In the bottom area of the page, select an Ethernet output port and click the canvas multiple times to add the
corresponding number of cabinets.
The cabinets will be automatically connected when you are adding them, as shown in
load capacity information will be displayed, as shown in
information, as shown
Figure 5-3 Cabinets connected automatically
Figure 5-4 Ethernet port load capacity

6/-: Indicates that 6 cabinets are connected to the controller's Ethernet port 1.
 34%: Indicates these 6 cabinets have used 34% of the Ethernet port's capacity.
Figure 5-5 Cabinet information
Note

If all the cabinets loaded by the Ethernet ports have the same size, you can use the swift layout function to
quickly add and connect the cabinets for all the Ethernet ports. The operations are as follows:

At the top right of the Ethernet port list, click
that match the actual requirements. In the properties area, select a layout and click Done.
Select another Ethernet port and continue to add cabinets until all cabinets are connected.
www.novastar.tech
Figure 5-5.
CX40 Pro LED Display Controller User Manual
Figure 5-4. The properties area will display the cabinet
. Then, drag the mouse on the canvas to add cabinets
5-3. The Ethernet port's
Figure
12