Advertisement
4.4 Security menu
Menu Item
Options
Set Supervisor Password
Power on Password
Enabled / Disabled
Full
User Access Level
View Only
Set User Password
USB Disks Signature Option
See Submenu
4.4.1
USB Disk Signature Option submenu
Menu Item
Options
USB Disks Signature Check
Enabled / Disabled
One
Time
Signature
Check
Enabled / Disabled
Disable
Signature Byte 0
0 ÷ 255
Signature Byte 1
0 ÷ 255
Signature Byte 2
0 ÷ 255
Signature Byte 3
0 ÷ 255
State Unknown / Installed / Not
USB Password
Installed
Set USB Disks Password
ETX-A61
ETX-A61 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Description
Install or Change the password for supervisor.
Length of password must be greater than one character.
Available only when Supervisor Password has been set.
Enabled: System will ask to input a password during P.O.S.T. phase.
Disabled: system will ask to input a password only for entering Setup utility
View Only: Access to BIOS Setup allowed but the fields cannot be changed.
Full: Any Field can be changed except the Supervisor Password
Install or Change the password for the users.
Length of password must be greater than one character.
Allow to enable or disable USB boot from signed USB disks only
Description
Enable the USB disk signature check.
When enabled, if the USB disk used is not signed it will be removed from the boot devices list.
One time disable of USB disk signature check.
When enabled, then for the subsequent boot only the USB disk signature will be automatically disabled.
Set the value for byte 0 of USB disks signature. The disk's signature check is always on 4 bytes.
Set the value for byte 1 of USB disks signature. The disk's signature check is always on 4 bytes.
Set the value for byte 2 of USB disks signature. The disk's signature check is always on 4 bytes.
Set the value for byte 3 of USB disks signature. The disk's signature check is always on 4 bytes.
This item shows the state of USB Disk Password for Boot
When a USB Disk password is set, the system will first check if the USB disk is signed. If it is not signed,
then the system will ask for a password, in order to continue booting from the USB disk.
61
Advertisement
