Single board computer with intel atom x series, intel celeron j / n series, intel pentium n series (formerly apollo lake) processors on picoitx form factor (68 pages)
SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
Check carefully that all cables are correctly connected and that they are not damaged. 1.5 Electrostatic discharges The SBC-C20 board, like any other electronic product, is an electrostatic sensitive device: high voltages caused by static electricity could damage some or all the devices and/or components on-board.
Page 13
2.1 Introduction SBC-C20 is a Single Board Computer, measuring just 101.6 x 147 mm (4” x 5,78”) based on embedded NXP i.MX 8M Family, featuring multicore processing (Dual ® ® or Quad ARM Cortex -A53 cores + general purpose Cortex -M4 processor).
Batteries supplied with SBC-C20 are compliant to requirements of European Directive 2006/66/EC regarding batteries and accumulators. When putting out of order SBC-C20, remove the batteries from the board in order to collect and dispose them according to the requirement of the same European Directive above mentioned.
2.5 Block diagram Power IN Backlight DDR3L soldered- DDR3L soldered- Connector LED Driver connector down memory down memory +12V DSI-to-LVDS LVDS connector eMMC bridge PMIC Power section CAN Controller + Power ON QSPI Flash Transceiver Connector + Button QSPI External SPI RGMII GPIO Connector LVDS_PWM_0...
3.1 Introduction On SBC-C20 board, there are several connectors located on the upper plane. Standard connectors are placed on the same side of PCB, so that it is possible to place them on a panel of an eventual enclosure. Please be aware that, depending on the configuration purchased, the appearance of the board can be significantly different from the following pictures.
Page 23
LED Driver connector SBC-C20 by iMX8M allow the direct control of LCD LED units. This functionality is allowed by WLED Controller p/n MP3385GR-Z driven by I2C interface of iMX8. This functionality is ensured by connector CN15, which is a 6-pin FFC/FPC connector, type HR P/N A1253WR-SF-06P, whose pinout is available in the table.