Single board computer with intel atom x series, intel celeron j / n series, intel pentium n series (formerly apollo lake) processors on picoitx form factor (68 pages)
Page 1
THEMIS Single Board Computer with NXP i.MX 8 Applications Processors in 3.5” form factor...
Page 2
SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
1.3 RMA number request To request an RMA number, please visit SECO’s web-site. On the home page, please select “CONTACT US” then “Online RMA” and follow the procedure described. An RMA Number will be sent within 1 working day (only for on-line RMA requests).
Check carefully that all cables are correctly connected and that they are not damaged. 1.5 Electrostatic discharges The THEMIS board, like any other electronic product, is an electrostatic sensitive device: high voltages caused by static electricity could damage some or all the devices and/or components on-board.
2.1 Introduction THEMIS is a Single Board Computer, measuring just 102 x 146 mm (4,02” x 5,75”) based on embedded NXP i.MX 8 Family, featuring multicore processing (Single ® ® ® or Dual ARM Cortex -A72 cores + Quad ARM Cortex -A53 cores + Dual general-purpose Cortex -M4 processor).
Page 15
Combo WiFi 802.11 a/b/g/n/ac + BT LE 4.2 module M.2 Socket 2 Key B Slot for M.2 Modems ** Measured at any point of SECO standard heatspreader for this product, M.2 Socket1 Key E Slot for WiFi + BT external modules during any and all times (including start-up).
Page 16
VIN_SYS Power requirement When powering THEMIS with a PSU with characteristics greater or equal to the one described in paragraph 2.3, please consider thoroughly the use scenario of the board (i.e., which peripherals will be connected) Since all the power must be supplied by a single external PSU, it must be cumulated the power consumption of the board itself with that of all external devices.
Page 21
3.1 Introduction On THEMIS board, there are several connectors located on the upper plane. Standard connectors are placed on the same side of PCB, so that it is possible to place them on a panel of an eventual enclosure. Please be aware that, depending on the configuration purchased, the appearance of the board can be significantly different from the following pictures.