Advertisement
4.3.5
LPSS & SCC configuration submenu
Menu Item
Options
ACPI Mode
LPSS & SCC Devices Mode
PCI Mode
LPSS & SCC Auto Switch
Disabled / Enabled
Hide Unsupported LPSS
Disabled / Enabled
Devices
SCC eMMC Boot Controller
Disable / Enable
eMMC Secure Erase
Disable / Enable
DDR50 Capability Support
Disable / Enable
HS200 Capability Support
Disable / Enable
0 / 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 /
Re Tune Timer Value
9 / 10 / 11 / 12 / 13 / 14 / 15
SCC SD Card Support
Disabled / Enabled
LPSS DMA #2 Support
Disabled / Enabled
LPSS I2C #1 Support
Disabled / Enabled
I2C Device Configuration
See Submenu
4.3.5.1
I2C Device Configuration submenu
Menu Item
Options
Device Type
Disabled / 7bits / 10 bits
0x0 ÷ 0xF (7 bit mode)
Address
0x0 ÷ 0xFF (10 bit mode)
Standard mode (100 Kb/s)
Speed
Fast mode (400 Kb/s)
ETX-A61
ETX-A61 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Description
Allows setting the Working mode of LPSS (Low-Power Sub-System) and SCC (Storage Control Cluster)
®
devices. Use PCI mode for Windows
Only available when "LPSS & SCC Devices Mode" is set to ACPI Mode.
Auto switches LPSS & SCC devices from ACPI mode to PCI mode when the O.S. does not support the
ACPI mode
Only available when "LPSS & SCC Devices Mode" is set to ACPI Mode.
Hide the unsupported LPSS devices
Disable or enable the eMMC Boot controller
Can be changed only when "SCC eMMC Boot Controller" is Enabled.
Disable or enable the eMMC Secure Erase. When enabled, all the data on the eMMC will be erased
Can be changed only when "SCC eMMC Boot Controller" is Enabled.
Enable or disable the DDR50 support for eMMC 4.5
Can be changed only when "SCC eMMC Boot Controller" is Enabled.
Enable or disable the HS200 support for eMMC 4.5
Can be changed only when "SCC eMMC Boot Controller" is Enabled and "DDR 50 Capability Support" is
Disabled. Sets the retune timer value
Enable/ Disable SD Card Support
Allows to enable second DMA Channel, which onboard is used to support the I2C Channel
Enable / Disable the I2C Bus available on ETX connector X4 (CN7)
Allows the installation of I2C Devices on ACPI aware OS
Description
Select the I2C device address format
Select I2C device address
Configure I2C Bus Speed
7, use ACPI mode for Android and Windows
®
8
50
Advertisement
