Advertisement
4.5 Power menu
Menu Item
Advanced CPU Control
EC Watchdog configuration
Thermal Zone configuration
Wake on PME
Auto Wake on S5
Wake from S5 time
Day of Month
LID_BTN# Configuration
LID_BTN# Wake Configuration
Power Fail Resume Type
ACPI Power off management
ETX-A61
ETX-A61 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.2 - Author: S.B. - Reviewed by G.G. Copyright © 2017 SECO S.r.l.
Options
Description
See submenu
These items control various CPU parameters
See submenu
Embedded Controller Watchdog Configuration Settings
See submenu
Thermal Zone Configuration: Active and Passive Cooling Settings.
Determines whether the system must wake up or not when the system power is off and occurs a PCI
Enabled / Disabled
Power Management Enable wake-up event (e.g. to enable Wake on LAN feature).
Disabled
Auto Wake from Soft Off State.
By Every Day
It can be set to wake every day at the same hour, or only a precise Day of Month
By Day of Month
Only available when Auto Wake on S5 is not set to disabled.
hh:mm:ss
Allows selecting the exact hour, minute and seconds for the automatic wake of the board
Only available when Auto Wake on S5 is set to By Day of Month.
0 ÷ 31
Allows selecting the day of month when the automatic wake must occur
Force Open
Configure LID_BTN# Signal as always open or closed (i.e., Force Open / Force Closed), no matter the pin
Force Closed
level, or configures the signal polarity: "Normal Polarity" means the signal goes High when open, "Inverted
Normal Polarity
Polarity" means the signal goes Low when open
Inverted Polarity
This item can be changed only when "LID_BTN# Configuration" is not set to Force Open or Force Closed.
No Wake
Only From S3
Configure LID_BTN# Wake capability. According to the pin configuration, when the LID is open it can cause
Wake From S3/S4/S5
a system wake from a sleep state
Determine the System Behavior after a power failure event.
In case the option is "Always ON", the board will start every time the power supply is present.
Always ON
When the option is "Always OFF", the board will not start automatically when the power supply returns.
Always OFF
Finally, if this option is set to "Last State", the board will remember the state it had when the power supply
Last State
went down: so, if the board was on, it will start again when the power returns, and will remain off if the
board was in this state when the power went down.
When enabled, the board will automatically switch itself to S5 state after OS shutdown.
When disabled, a manual Power off is required
62
Advertisement
