Single board computer with intel atom x series, intel celeron j / n series, intel pentium n series (formerly apollo lake) processors on picoitx form factor (68 pages)
SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
Check carefully that all cables are correctly connected and that they are not damaged. 1.5 Electrostatic discharges The SBC-C43 board, like any other electronic product, is an electrostatic sensitive device: high voltages caused by static electricity could damage some or all the devices and/or components on-board.
Page 13
2.1 Introduction SBC-C43 is a Single Board Computer, measuring just 102 x 146 mm (4,02 x 5,75 ) based on embedded NXP i.MX 8 Family, featuring multicore processing (Single or Dual ARM Cortex®-A72 cores + Quad ARM Cortex®-A53 cores + Dual general purpose Cortex®-M4 processor).
M.2 Socket 2 Key B Slot for M.2 Modems M.2 Socket1 Key E Slot for WiFi + BT external modules ** Measured at any point of SECO standard heatspreader for this product, during any and all times (including start-up). Actual temperature will widely depend on application, enclosure and/or environment.
Power available When powering SBC-C43 with a PSU with characteristics greater or equal to the one described at beginning of previous paragraph, please consider well what is the typical scenario for using the board (i.e., which peripherals will be connected) Since all the power must be supplied by an external PSU only, please balance well the typical final configuration, considering both the power consumption of the board itself and the power consumption of external devices.
Page 17
Batteries supplied with SBC-C43 are compliant to requirements of European Directive 2006/66/EC regarding batteries and accumulators. When putting out of order SBC-C43, remove the batteries from the board in order to collect and dispose them according to the requirement of the same European Directive above mentioned.
Page 21
3.1 Introduction On SBC-C43 board, there are several connectors located on the upper plane. Standard connectors are placed on the same side of PCB, so that it is possible to place them on a panel of an eventual enclosure. Please be aware that, depending on the configuration purchased, the appearance of the board can be significantly different from the following pictures.