Table of Contents
Advertisement
ERROR MESSAGES
8. After retrieving the sample, close the chamber door, then replace the
front panel on the instrument. Insert the tabs at the bottom of the panel
onto the lip at the base of the instrument, being sure to align the front
panel with the side panels. (See Figure 9-4)
9. Lift the front edge of the top panel a few inches and insert the upper edge
of the front panel under it. Push back gently to engage the tabs, then
down to activate the latch.
10. Replace the control head by sliding it along the small ridges provided,
making sure to clear the printer on top and the emergency power switch
in front. When the control head cover is correctly positioned, push it until
the latches snap shut and the cover is aligned with the rest of the instru-
ment panels.
11. Return the key to the interlock switch.
Align Panel
Figure 9-4. Reinstalling the Front Panel
If you make an error that interferes with the instrument's operation, an error
message will appear below the CURRENT VALUES window and a tone will
sound. Follow the prompt to correct the error and then proceed.
Troubleshooting and Maintenance
Front Panel Tabs
9-5
Advertisement
Table of Contents
