Configuring The Smartotdr Via Ethernet - Viavi SmartOTDR Mainframe User Manual

Chapter 7 Connectivity
Establishing connection
2 Make sure the network configuration onto the PC is set to the Dynamic mode:
a
b
c
d
e
f
g
Figure 41 Internet Protocol
h

Configuring the SmartOTDR via Ethernet

1 In the Home page, validate the Connectivity icon.
2 In the connectivity page, validate the Ethernet icon
3 In the I/O Interfaces box, configure the following parameters:
Remote Screen
Remote screen
face E/S window.
54
Click on Start > Control Panel.
Double click on Network Connection.
Double click on Local Area Connection.
In the dialog box, click on Properties.
Check the parameter Internet Protocol (TCP/IP) is selected (
once on it (underlined in blue)
Click on Properties button.
On the tab General, check the parameter Obtain an IP address automati-
cally is selected ( ); if not, click to select it.
Click on Ok and close all the dialog boxes opened onto the PC.
= Session or
User Manual
Permanent must be confirmed in both cases, in the Inter-
7SMART102 Rev006
) and click